The clutch connects the engine to the gearbox and enables gear changes and starting. The Fiat Uno is equipped with a dry clutch, single disc with central spring.
Clutch replacement
The clutch can be disassembled after taking the gearbox out of the car
■ Use a scribe to mark the relative position of the clutch holder and the flywheel. Loosen gradually and crosswise” bolts securing the holder to the flywheel.
■ Completely remove the mounting bolts and take out the support with pressure ring and clutch plate.
When installing the coupling, pay attention to the marked markings {does not apply to the new clutch). Center the clutch disc with the guide pin, for example, an old clutch shaft. If such a spindle is not available, it is possible to center the shield visually with slightly screwed in mounting bolts of the housing. After installing the gearbox, depress the clutch pedal three times and adjust its height .
In doubtful cases, it is recommended to replace the fitting, clutch disc and release bearing, which is mounted on the input shaft and connected by catches to the release lever. A symptom of a faulty release bearing is the noise that accompanies the clutch disengaging. Leaving the old retainer ring on after replacing the clutch plate can cause this. that the clutch will no longer disengage the drive properly.