Englishman's Vehicle, John Bevers

John BeversThe Englishman's vehicle built in the eighteenth century deserves a mention, John Bevers. It was a small four-wheeled vehicle, in which you sat comfortably, steering the front wheels with a "funnel"”; while the servant, standing behind the passenger compartment, trampled on the pedals of the crank mechanism, connected by a gearbox … read on

Hyundai Galloper 2.5 TD – Engine and chassis

The Galloper chassis with independent suspension on torsion bars at the front and a rigid bridge on coil springs at the rear corresponds to the Pajero structurally. Thanks to the wide tyres with good grip, you can negotiate corners at a fairly high speed, but at maximum load not always … read on

Hyundai Galloper 2.5 TD

Hyundai GalloperSuch a large trailer as the Galloperra can not be attached to any other off-road station wagon. In addition, the powerful turbo-diesel guarantees it a fast enough ride even with the heaviest trailer. The earlier Pajero L040 could in its time pull a trailer with maximum weight 2.500 … read on

Fuel tank replacement – Opel Cadet

Fuel tank replacement

The fuel tank cannot be emptied by sucking the gasoline through the filler pipe. as the ball check valve located therein prevents the insertion of the tube. Proceed as follows to remove and install the tank.

■ Odłączyć przewód masowy akumulatora.… read on

TRANSISTOR IGNITION (ENGINE 1,3) – Opel Cadet

TRANSISTOR IGNITION (ENGINE 1,3)

Electronic engine ignition system 1.3 It is equipped with a contactless ignition distributor with a magnetoinductive sensor and an electronic module.

In the engine compartment there is a plate with the words "Leistungsges-teigerte Zundanlage”, which informs, with the engine running, do not touch any part of the ignition system. … read on

Checking the elements of the ignition system – Opel Cadet – Engine 1.2

Checking the elements of the ignition system

The ignition coil

The efficiency of the ignition coil can be checked as follows.

■ Remove the end of the lead wire from the ignition coil from the distributor cap.

■ Remove the manifold cap.

■ Rolling the car with the gear engaged, cause the circuit breaker contacts to close.

■ Włączyć zapłon i zbliżyć do … read on