automotive, cars
Master cylinder repair
■ Remove the master cylinder (see description in the previous section).
■ Remove the screw plugs from the pump.
■ Slide all parts out one by one. If necessary, blow out with compressed air supplied to the rear socket. Części odkładać w kolejności wyjmowania.… read on
Master cylinder replacement – Fiat Uno
■ Disconnect the electric wires from the brake reservoir cover.
■ Drain the brake fluid from the reservoir.
■ Unscrew the brake lines to the pump. Lift the wires, not excessively bending them.
■ Odkręcić pompę od serwa i wyjąć.… read on
Fiat Uno cars are equipped with a dual-circuit braking system acting on the front discs, while at the rear for the brake drum (Engines 900,1100.1300,1300 D. 1700 D) or a shield (engine 1300 Turbo). The system is equipped with a brake force regulator and a mechanism … read on
Rear wheel bearing replacement – Fiat Uno
The replacement of the rear wheel bearing consists in the replacement of the complete hub.
■ Raise the rear of the car and remove the wheel.
■ Remove the brake drum or disc.
■ Remove the cup from the hub.
■ Undo the hub spigot nut and unscrew it.
■ Ściągnąć piastę … read on
Replacing the rear shock absorber – Fiat Uno
■ Loosen the rear wheel bolts, do not remove the wheel yet.
■ Unscrew the upper shock absorber fastening on the luggage compartment side.
■ Lift the rear of the car and place it on the stands, remove the rear wheels.
■ Support the rocker arm with a vehicle jack, without lifting it.
■ Odkręcić śrubę … read on
REAR SUSPENSION – Fiat Uno
The rear suspension consists of a torsionally steel beam, to which the longitudinal arms are welded. The beam with wishbones is attached to the body by metal-rubber bushings. The spring elements of the suspension are coil springs, while the vibration damping element are telescopic shock absorbers, mocowane obok … read on
Checking the wheel alignment – Fiat Uno
The alignment of the front wheels has a decisive influence on the steerability, vehicle driving characteristics and tire wear. The toe-in should be checked after any suspension repair or any abnormal symptoms in the steering system, wheel camber and steering knuckle pins. Do pomiaru pochylenia koła i … read on
Wheel bearing replacement
Front wheel bearing, which is loud or has a lot of slack. needs to be replaced. It is recommended to replace the bearing together with the hub, as it is a simpler repair and requires no special tools (the clamping nut of the outer ring of the bearing has an inner hexagon).
■ Wymontować kolumnę zawieszenia … read on